ECUMaster EGT to CAN
Posted: Thu Aug 08, 2024 8:31 am
Hi All,
Hoping for some help for the following please.
I'm trying to setup an ECUMaster EGT to CAN input via CAN 3 on my M150 R35 package.
I have ECU Receive set to CAN Bus 3, 0x0600Hex, message type = Sequential
I've tried all variations of the following.........
Sensor Resource to CAN 3 Offset 0,2,4 & 6
CAN 0DP.1.0 and CAN 1DP.1.0
Pulling out what's left of my hair here lol
Please see the attached screenshots.
Cheers
Ian
Hoping for some help for the following please.
I'm trying to setup an ECUMaster EGT to CAN input via CAN 3 on my M150 R35 package.
I have ECU Receive set to CAN Bus 3, 0x0600Hex, message type = Sequential
I've tried all variations of the following.........
Sensor Resource to CAN 3 Offset 0,2,4 & 6
CAN 0DP.1.0 and CAN 1DP.1.0
Pulling out what's left of my hair here lol
Please see the attached screenshots.
Cheers
Ian