MoTeC Global Forum

Hey all

I’ve just picked up a 2016 Subaru STI, running a Motec m150

Car runs really good, apart from a few things I’m trying to figure out on the fly

I come from a Link background, the Motec software is a little overwhelming but I’m getting use to the pages & workbooks

I’m having a slight issue with trying to get the low & high cooling fans working right

Attached is just a snapshot of the fans, they were physically working (one was not both) but the voltage reading 0, when the fans are off the voltage reads alternator voltage.

I’ve tried changing some things around, I did manage to get the low fans working with AC on (but the high fan didn’t come in at 88deg)

Can anyone help here, it looks simple enough but something is backwards or am I just navigating wrong?

Thanks.

Hi,

As this is a Powertune Australia Firmware Package, you will need to speak to them.