MoTeC Global Forum

I get a lot of CAN error messages in the ECU Monitor View of the M1 Tune application.
The following items are connected to CAN port 1:
M130 ECU
C125 Dash
E888 Expansion unit
MoTeC 15 button keypad
LTCD Lambda to CAN module
Attached is a logfile of the CAN error messages. I`ll appreciate if anyone can help me identify the cause of these and hopefully sort the problem.

Have you set ECU Transmit CAN Bus to 'CAN Bus 1'.

Check ECU Receive CAN bus too.

I believe the Geartronics code failed to check if a Valid CAN bus was selected before attempting to transmit their status.

You should report this to RDS or the developer of your package that is using the Geartronics firmware code.