MoTeC Global Forum

Hi

Just confirming to make sure I have read the help correctly.

I am on a 60-2 crank trigger pattern (machined into the flywheel) triggering a hall effect sensor. The leading edge of the first tooth after the gap is at 60 degrees AFTER top dead center.

So, do I enter -60 as the engine speed reference offset, with trigger on rising edge?

Thanks in advance

Can anybody confirm?

That is correct.

SDean wrote:That is correct.

Thanks for confirming Stephen. Didn't want to spend hours trying to get the engine to start for the first time on a misunderstanding...it's going to be nerve racking enough as it is!