Page 1 of 1
M150 to AIM MXL2
Posted:
Tue Jun 02, 2015 5:49 amby yorl
I am wiring an M150 to one of our customer's rally car, and its got an AIM MXL2 dash. I didn't find information on the AIM website regarding the connection to the M150, only the "older" systems. Anyones got info on that?
Thanks!
Re: M150 to AIM MXL2
Posted:
Tue Jun 02, 2015 8:16 amby David Ferguson
What info do you need?
You connect CAN Hi/+ & Lo/-, and in AiM Race Studio 3, select ECU Manufacturer = Motec, and Model = M1.
The MXL2 does not have a CAN terminating resistor, so you'll need to terminate your CAN bus appropriately.
Re: M150 to AIM MXL2
Posted:
Wed Aug 05, 2015 5:05 amby yorl
That was it, the resistor. Didn't know if it needed one or not. Thanks
Re: M150 to AIM MXL2
Posted:
Wed Aug 05, 2015 6:06 amby David Ferguson
Thanks for letting us know what was needed. Good luck with your project.