Autoblip M130 Triumph

[cw200@live.com]

Does anyone have an example of auto blip setup in an M series ecu for a bike I am in the process of setting it up on a Triumph 765RS Moto 2 engine just want something to compare to so really any bike would be fine. Cheers

[David Ferguson]

Do you have drive-by-wire throttle on that engine? The only blip function in MoTeC GP firmware packages requires a DBW throttle.

You can download the GPRP firmware package to see an example of the blip configuration.

The M1 GPRP Configuration Manual will show you how to configure this. You can download it from here:

https://www.motec.com.au/hessian/upload ... 0c1d18.pdf

[cw200@live.com]

Hi David,

Yes the bike is DBW I have the manual and have read through it, we have been running the package for 12 months with upshift. I have set it up but I am yet to test it was looking to compare against another bike as the pdf per your link is based around paddle shift in a car there isn’t really anything for a bike. Cheers

[Stephen Dean]

What Firmware are you running in the M1?

[cw200@live.com]

Firmware is version 01.00.0001
Firmware - Triumph 765 2022 BSS

[Stephen Dean]

Some of the targeted firmware's, such as the BSS Firmware have restrictions on the functionality that they can run, you will need to contact MoTeC Europe's support for this question, as they are the people that developed the Firmware.

[cw200@live.com]

I have asked the question I don’t believe that it has any restriction on the auto blip function but I will confirm the EU. Cheers

PS : has anyone ever suggested a bike only section in the forum?

[cw200@live.com]

Eu have confirmed that there is no restriction on auto blip.

[Stephen Dean]

At the least we would need to see your package.

[cw200@live.com]

PM me your email and I will send it through. Cheers