Hi Stephen,
the German importer told me to send the mail direct to Alan Bell@moteceurope.co.uk
Regards Ralf
DBW
14 posts
• Page 2 of 2 • 1, 2
Re: DBW
by Ralle#67 on Mon Mar 07, 2022 3:37 am
Hello,
I tried to start the engine today.
But there were only a few ignitions and the engine did not start.
The error message was "Engine Synchronization"
Unfortunately, I'm not that familiar with the M 170. that I can interpret.
I have attached a log file.
I tried to start the engine today.
But there were only a few ignitions and the engine did not start.
The error message was "Engine Synchronization"
Unfortunately, I'm not that familiar with the M 170. that I can interpret.
I have attached a log file.
- Attachments
-
S1_#13135_20220306_171040.ld- (7.71 MiB) Downloaded 308 times
- Ralle#67
- Posts: 64
- Joined: Tue Jun 08, 2021 1:39 am
Re: DBW
by Stephen Dean on Mon Mar 07, 2022 11:09 am
Hi Ralf,
As you are running the EU-SBK firmware, you will need to contact MoTeC Europe for support as this is a Package that they have specifically written for that series.
As you are running the EU-SBK firmware, you will need to contact MoTeC Europe for support as this is a Package that they have specifically written for that series.
Stephen Dean
MoTeC Research Centre Melbourne, Australia
MoTeC Research Centre Melbourne, Australia
-
Stephen Dean - Site Admin
- Posts: 1690
- Joined: Tue Dec 02, 2014 10:29 am
- Location: Melbourne
14 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: Bing [Bot] and 35 guests