I'm moving from M400 over to M130. The wiring isn't completed yet but while playing with setting up all the parameters through the M1 tune, I can't seem to be able to select Universal Digital Input 1 for the Ref signal. Why is that?
Cheers
Missing Universal Digital Input 1?
4 posts
• Page 1 of 1
Missing Universal Digital Input 1?
by mr2andy on Thu Aug 24, 2017 9:47 pm
- mr2andy
- Posts: 135
- Joined: Sat Aug 29, 2009 10:54 pm
Re: Missing Universal Digital Input 1?
by David Ferguson on Fri Aug 25, 2017 4:27 am
Because it's been selected for something else. Use Tools->Edit Input/Output Resources... or Help->Firmware Wiring... to discover what that is.
David Ferguson
Veracity Racing Data
Veracity Racing Data
- David Ferguson
- Pro User
- Posts: 1419
- Joined: Fri Nov 07, 2008 2:45 am
- Location: Paso Robles, California
Re: Missing Universal Digital Input 1?
by Stephen Dean on Fri Aug 25, 2017 10:06 am
Hi,
UDig1 is forced to be the Engine Speed Reference signal input in the firmware, this can not be changed by the end user. This is done as the UDIg1 pin is designed to accommodate the high rate of signal inputs that can be received using 60-2 and higher tooth counts.
UDig1 is forced to be the Engine Speed Reference signal input in the firmware, this can not be changed by the end user. This is done as the UDIg1 pin is designed to accommodate the high rate of signal inputs that can be received using 60-2 and higher tooth counts.
Stephen Dean
MoTeC Research Centre Melbourne, Australia
MoTeC Research Centre Melbourne, Australia
-
Stephen Dean - Site Admin
- Posts: 1759
- Joined: Tue Dec 02, 2014 10:29 am
- Location: Melbourne
Re: Missing Universal Digital Input 1?
by mr2andy on Sat Aug 26, 2017 9:44 am
That's what I thought, just need to confirm. Thanks Dean.
- mr2andy
- Posts: 135
- Joined: Sat Aug 29, 2009 10:54 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 13 guests