MoTeC Global Forum

A webinar on building wiring looms,

Crimping, joining, splicing, heatshrink and general tips and techniquies to build sucessfull and reliable looms would be amazingly helpfull !!

I second that,
As Motec indicate in their installation manual blurb that most problems are caused by poor wiring it would seem logical that this should be top of the list before worrying how to tune the ecu for beginners and even some pro's would benefit I'm sure.
I spent a lot of time making mistakes before someone showed me 'how its done properly'.

Good suggestion tricky !

sounds like a good idea to me..

Ill add it to the list of upcoming webinars.

-Jamie

Thats excellent news ! It would be a breath of fresh air to see some 'practical' webinars.

Thanks Motec

Maybe including references to suitable crimp tools etc ( affordable ones lol )

This would be so helpful.

Being able to correctly wire your ECU / ADL etc is clearly its one of the biggest obstacles to Motec ownership.

My earlier wiring attempts have taught me enough to know that I need to know much more for my next car build.

I agree. It took me a lot of time to do it (more or less) right. Even the basics (like use stress relief loops for splices of wires) are good things to teach. There are resources out there, but it takes a lot of time to find them.

Any development regard this webinar ?

also checking on any updates for this webinar

Not a webinar, but seen someone link to this on another forum, good info there

https://www.rbracing-rsr.com/wiring_ecu.html

https://www.rbracing-rsr.com/wiring_ecu.html#supplies