Page 1 of 1
M84 Knock sensors
Posted:
Thu Jan 28, 2021 9:50 pmby Jimster
Hi There,
is it possible to connect knock sensors to the M84 directly, or would I need an additional interface?
Thanks
Jim
Re: M84 Knock sensors
Posted:
Fri Jan 29, 2021 8:31 amby Stephen Dean
Hi,
The M84 does not have support for knock sensors in the hardware and is not able to use an external device for this either as there is no support in the Firmware for any knock control.
Re: M84 Knock sensors
Posted:
Sun Mar 14, 2021 2:36 amby Vlad
You can do a ignition trim based on a 0-5v from a external knock detection device (ex Phormula KS, etc) but is not very effective, as it's only momentarily, and you cannot set the severity of it's reaction... Might save the engine in one or two cases thow