MoTeC Global Forum

Posted: **Wed Jul 11, 2012 5:49 am**

New to Motec so still learning the ropes.
Whenever I try to select View Device Config, I get the error below, any idea what's causing this ?

Posted: **Mon Jul 16, 2012 10:58 am**

do you have the latest i2 installed?

do you also have the latest version of the softwre it is trying to open also installed (assuming m84 ECU manager?)

-Jamie

Posted: **Mon Jul 30, 2012 6:32 am**

Latest version of i2 installed and firmware is 1.10N
Tried reinstalling but still get the same......

Posted: **Mon Jul 30, 2012 7:04 am**

Did a bit of rootling around on the PC (registry etc) before finally sussing it, it was fairly straight forward in the end. :roll:

Just need to go to the i2 properties- compatibility and change the privilege level to run it as an administrator :idea:

MoTeC Global Forum

View Device Config

View Device Config

Re: View Device Config

Re: View Device Config

Re: View Device Config