MoTeC Global Forum

Hi

Can I use Chase cam PDR100 rev5 on M84 ?

I need "only" RPM and TPS value from M84 on video.

How I can setup M84 for this job ?

In this manual http://www.motec.com/filedownload.php/M ... docid=3087 I can't find any information about wiring conection and setup motec software for this.I found pin out for DTM8 connector,but I don't know how to setup M84 to chase cam over RS232 TX-RX line.

Can someone explain how to connect the chase cam and setup soft ?

Thanks

Hello,
The M84 does not send out any RS232. The communications for the M84 is locked to only MoTeC devices.

Thanks for answer.

OK,If the M84 is not support this,can I use SDL RS232 output to connect this cam ?

I think it has been done. Since we make our own video system we have not put to much effort into supporting other brand system.