MoTeC Global Forum

We put a C125 with a GPS–L10.

GPS reads properly, speed, G-sensors, altitude all work fine.

I would like to utilize the Odometer channel as well as the trip meter. Its not working at all. Thoughts on how to setup the channels.

Once it actually begins to work, I would like to setup a reset for the trip.

In the calculations tab, Speed and Distance.
Both Odometer and Trip are turned "on" and my reset pin is setup as a condition.

Thanks,

According to the Speed & Distance setup help, both of those odometers use the "Ground Speed" channel. Is this channel being generated from your GPS speed?

Yeah I think its resolved. I feel kind of stupid to be honest. The kind folks at MoTeC tech support looked at my settings and I had the reset condition as >=0 well considering its a digital signal (0 or 1) that condition had it in a perpetual reset. Just have to change the value to =1.