Need Start file for Ford 427 7 litre V8 for M800...
Posted: Thu Apr 09, 2009 10:39 pmHello,
It's my first post on this forum and I'm asking if anybody on this forum could provide me with a start file:
ECU: Motec M800 software 3.5 ver
Engine: Ford 427 Cu in./ 7 litre V8 - 450-500 estimated HP, normally aspirated
Trigger mode: Accel dual sync distributor
Fuel pressure: 45 psi - Aeromotive A1000 fuel pump
Ignition: MSD 6AL ignition
Injection: Siemen Deka 55 lb/hr, ( 577 cc/min ) lo-impedance peak and hold fuel injectors
Senors: 1 Bar Map, AT, ET
Thank you in advance and regards,
Ken
It's my first post on this forum and I'm asking if anybody on this forum could provide me with a start file:
ECU: Motec M800 software 3.5 ver
Engine: Ford 427 Cu in./ 7 litre V8 - 450-500 estimated HP, normally aspirated
Trigger mode: Accel dual sync distributor
Fuel pressure: 45 psi - Aeromotive A1000 fuel pump
Ignition: MSD 6AL ignition
Injection: Siemen Deka 55 lb/hr, ( 577 cc/min ) lo-impedance peak and hold fuel injectors
Senors: 1 Bar Map, AT, ET
Thank you in advance and regards,
Ken