MoTeC Global Forum

Hi!
Anybody who have done or maybe have a working file for a 13B wankel engine?
Have 260BHP on carb's but wery poor respons on low revs ,good power on high revs.
I have only worked on theese engines with carbs and nobody here have succed wit any stand alone ECU's.
So,if some one have done this with a M-4 or M2R i would be wery happy for all information as i am new to this.
Possible attach a tuned file i can look at to see howe this should be done,even an RX8 tuned file would be good.
This is a N/A engine(non turbo)

Regards

Brede

Hi Brede,

MoTeC ECUs have been successfully installed on 13Bs before as well as on RX8 engines. There is a start file for an RX7 that comes with the installation of M2R software.

Brede,
I have a 20B N/A file if you want to have a look at that and use some ideas from that.
Just pm your email to me and I can sen it to you.

Hi!

Anybody who have a working file for a 20B wankel engine?

Have no experience with wankel, need help with the setup!


Regards

Arve Flaat
arve-fla@online.no

I'd like a 20B file also so i can see if what i'm doing is in the ball park.
20B PP