Page 1 of 1

brake bias setting

PostPosted: Tue Feb 08, 2022 7:41 pm
by andy
I wonder how the brake bias setting was set up.

I wonder why the graph came out like this.

brake bias.jpg
brake bias.jpg (390.16 KiB) Viewed 3653 times





'Brake Pres Front' [bar] / ('Brake Pres Front' [bar] + 'Brake Pres Rear' [bar] )

I wonder if you can calculate it only when the pressure is 1 or higher.

I wonder if this is the right setting.

Re: brake bias setting

PostPosted: Wed Feb 09, 2022 3:28 am
by David Ferguson
Here is the Dynamic Brake Bias math setup that I use:

Brake Bias w-Invalid().JPG
Brake Bias w-Invalid().JPG (107.77 KiB) Viewed 3637 times


Notice I use the choose function to check for minimal pressure on both channels, and the invalid() function to say the channel is invalid with the current pressure values.