MoTeC Global Forum

Just a quick note to say love the new acceleration report.

any info anywhere on how to use it?

I am in the process of writing some documentation on how it works. In the mean time is there anything in particular you want to know about it?

What is purpose of this new tool and how to use it?

Very basically the acceleration report gives you information on how long it takes to get from one speed to another. You can customise the speed thresholds and the information it gives you (ie amount of time/Distance or G Force).

It is good for looking at how the acceleration of the car changes over the course of a race, say from changing fuel load or drive line losses etc.

If you create an acceleration report you will see that it shows you just over 1 lap (a bit of overlap at the start and end) and it splits up each of the acceleration zones (positive and negative). You can select each zone to see the acceleration or deceleration times for that zone and the min and max for the lap are also shown.

Details of the Acceleration Report can be found in the I2 v1.1.4 Feature Guide Document:

https://www.motec.com.au/filedownload.p ... docid=5678

Thanks David, that's handy.