MoTeC Global Forum

Hi,
do logged Knock1/Knock2/Knock3/Knock4 indicate cylinders #1/#2/#3/#4, or in firing order (for example cylinders 1-3-4-2)?
Thanks

Tools/Channel Mappings. Rename the channels in Channel Mapping by firing order, log data channels are created by output order and need to be remapped to proper cylinder. In the case of common 4 cyl firing order 1-3-4-2 Knock 1 = 1, knock 2= 3, knock 3 =4, knock 4 = 2

Applies to all firing order effected outputs I believe.

Scott@FP wrote:Tools/Channel Mappings. Rename the channels in Channel Mapping by firing order, log data channels are created by output order and need to be remapped to proper cylinder. In the case of common 4 cyl firing order 1-3-4-2 Knock 1 = 1, knock 2= 3, knock 3 =4, knock 4 = 2

Applies to all firing order effected outputs I believe.

Hi Scott,
sorry but still confusing...
My injectors and coils are wired in firing order, and also set up the Firing Order 1/3/4/2, so which is the output order the log is following for the knock channels?
Thanks

You need to do this to get the cylinder # correct for the SKM/OKM in i2

Scott@FP wrote:You need to do this to get the cylinder # correct for the SKM/OKM in i2

Yes, I made it yesterday and it works, thanks!