Page 1 of 1
creating a ref lap in i2 pro for SDL
Posted:
Thu Jun 13, 2013 10:14 pmby FoxPerformance
when using the latest version of i2 pro and SDL dash manager: I can create a reference lap in i2 pro, but then when trying to browse for it and send it to the dash using SDL dash manager, the dash manager software does not see the reference lap in the folder.
i have verified that the lap was created and sent to the same folder that sdl manager is looking in.
I also saved a ref lap to the desktop and "browsed" for it on the desktop but SDL manager does not see the file type that it is saved as.
Re: creating a ref lap in i2 pro for SDL
Posted:
Fri Jun 14, 2013 3:46 pmby FoxPerformance
Crickets....
Re: creating a ref lap in i2 pro for SDL
Posted:
Fri Jun 21, 2013 11:00 amby Sean
The reference lap created by i2 has the .td1 extension? Is SDL manager looking for an incorrect extension?
Re: creating a ref lap in i2 pro for SDL
Posted:
Fri Jun 21, 2013 1:31 pmby YuriK
No, SDL is looking for the correct extension. Check that it is looking in the right directory.
Regards!
Re: creating a ref lap in i2 pro for SDL
Posted:
Thu Jun 27, 2013 1:23 pmby FoxPerformance
Did you read my post.
I specifically saved the reference lap I created in i2 to te desktop.
I then could not "see" this file from the sdl manager when I was trying to send it to the dash.
In the manager software I searched the desktop for the ref lap and it would not view it.
I could plainly see the saved ref lap outside the manager software on my desktop.
Re: creating a ref lap in i2 pro for SDL
Posted:
Thu Jun 27, 2013 3:04 pmby YuriK
What version of SDL manager are you running?
What Operating system is installed on your laptop?
Send me the ref lap file to
yuri.khodos@motec.com.au