Target Lambda in I2

[Iggsy]

Is it possible to have the target lambda as a function of throttle position and RPM in the i2 software that I can use to compare against the actual logged lambda value?

[David Ferguson]

Is there a reason you don't just log the target lambda channel?

What device is creating the log file?
If it's a dash, you could set up a 3D table to generate this channel if you aren't getting it from the ECU.

[Iggsy]

Hello David.

I have an older ecu (M48) in open loop. I don’t think it’s possible to log the target channel on the m48.

I have AIM dashes.

Regards.

[Sean]

It can be done in i2 Pro (but not in i2 Standard). In the maths window, go to create a 3d table, I'd think linear interpolation would work best. Screen shot below of a rough one I just tried.

3d lambda table sample.jpg (97.07 KiB) Viewed 32 times