ALS CAN BUS
Posted: Sat Oct 07, 2017 5:42 pmHi everyone
Is there a way to tell M800 PNP ecu to turn on ALS(anti lag) via CAN BUS?
Is there a way to tell M800 PNP ecu to turn on ALS(anti lag) via CAN BUS?
MoTeC Global Forum
The official support forum for MoTeC products
https://forum.motec.com.au/
ALS CAN BUS
Page 1 of 1
Posted: Sat Oct 07, 2017 5:42 pmRe: ALS CAN BUS
Posted: Sun Oct 08, 2017 7:28 amYes, thru a digital input set up as a switch. Set up switch to use source and channel of the CAN device you are using.
Re: ALS CAN BUS
Posted: Fri Oct 13, 2017 2:56 amThank you Scott!