Page 1 of 1
Wiring anti lag and launch control
Posted:
Wed Apr 14, 2010 7:27 amby JOHNDQ
Hi can anyone help with the above please? I have a Evo VII (EVO48 on circuit board) Just need to know how to wire up the two systems, all the unlocking and maps etc will be taken care of by my mapper
Many thanks for your help John
Re: Wiring anti lag and launch control
Posted:
Wed Apr 14, 2010 8:23 amby xpro
If your car has an intercooler spray you can use that for ALS on/off, no need for extra wiring,use digital input function 13. Launch control , also use digitial input and function 14. you might need to add a switch for that,
Re: Wiring anti lag and launch control
Posted:
Wed Apr 14, 2010 8:35 amby JOHNDQ
Thanks for your reply mate, i take it i have to connect the wires into the control unit so it gets the demand for the AL and LC do you have any idea which pins these are?
Many thanks again John
Re: Wiring anti lag and launch control
Posted:
Wed Apr 14, 2010 6:50 pmby xpro
I dont have the pinout for motec board 48, but i can give you an oem 7 ecu pinout if thats any good to you
Re: Wiring anti lag and launch control
Posted:
Wed Apr 14, 2010 10:18 pmby JOHNDQ
I got one from MLR mate thanks, i think i may have seen you there to after a throttle kicker
Re: Wiring anti lag and launch control
Posted:
Thu Apr 15, 2010 8:40 amby xpro
JOHNDQ wrote:I got one from MLR mate thanks, i think i may have seen you there to after a throttle kicker
yes im on mlr too
Re: Wiring anti lag and launch control
Posted:
Thu Apr 15, 2010 10:26 pmby JOHNDQ
Any luck finding one