Evo 9 boost control

Covers current and earlier Subaru and Mitsubishi Plug-In systems

Evo 9 boost control

Postby jurgen on Wed Sep 17, 2008 6:02 am

I have problems by setting up a PID boost control on an evo9. car doesnt make more boost dan 1.6 bar. wich jet do i have to yuse and what pid corrections??? anyone a base map for that??
jurgen
 
Posts: 14
Joined: Mon Sep 15, 2008 6:13 am

Re: Evo 9 boost control

Postby Mazi on Wed Sep 17, 2008 8:42 am

If you have two boost control solenoids jet should be 0.9 or 1.0mm bore and 7mm long. With single solenoid 1.2 mm.
With two solenoids you have to check if pins 41 and 63 are linked together. Try to run ign3 output test (DO NOT FORGET TO DISCONNECT IGNITION COILS FIRST!) and try to find out which solenoid is making sound. If both boost control solenoids are disconnected there must be no sound around engine during ign3 output test. Sometimes........ ;)

Are you running v3.4x firmware or previous version?
MAP or MAF controlled?
User avatar
Mazi
 
Posts: 146
Joined: Thu Jul 24, 2008 8:45 pm

Re: Evo 9 boost control

Postby jurgen on Sat Sep 20, 2008 8:13 am

I'm running 3.4 software with map
jurgen
 
Posts: 14
Joined: Mon Sep 15, 2008 6:13 am

Re: Evo 9 boost control

Postby Mazi on Sat Sep 20, 2008 9:50 pm

Jurgen
Send me your email address on PM.
User avatar
Mazi
 
Posts: 146
Joined: Thu Jul 24, 2008 8:45 pm


Return to M800 Plug-In ECUs

Who is online

Users browsing this forum: No registered users and 5 guests