Subaru EJ25 Block / EJ20 Heads to Start Semi-Sequential

Covers current and earlier Subaru and Mitsubishi Plug-In systems

Subaru EJ25 Block / EJ20 Heads to Start Semi-Sequential

Postby dochka on Sun Sep 15, 2024 6:12 am

Hi,
There's a trigger "mismatch" with this engine, I'm planning to run it only on the Crankshaft sensor, trigger wheel is 36-2-2-2 ;
How to setup this in ECU Manager ?

Thanks in Advance
dochka
 
Posts: 4
Joined: Wed Jun 22, 2011 7:23 am

Re: Subaru EJ25 Block / EJ20 Heads to Start Semi-Sequential

Postby Stephen Dean on Mon Sep 16, 2024 10:59 am

Hi,

Short answer is that you cannot do this. There is not a Ref only mode that supports the 36-2-2-2 trigger pattern used in the Subaru engine, using the Subaru Mode will generate an engine speed but it will not synchronise.
Stephen Dean
MoTeC Research Centre Melbourne, Australia
User avatar
Stephen Dean
Site Admin
 
Posts: 1729
Joined: Tue Dec 02, 2014 10:29 am
Location: Melbourne

Re: Subaru EJ25 Block / EJ20 Heads to Start Semi-Sequential

Postby dochka on Tue Sep 17, 2024 10:38 pm

Stephen Dean wrote:Hi,

Short answer is that you cannot do this. There is not a Ref only mode that supports the 36-2-2-2 trigger pattern used in the Subaru engine, using the Subaru Mode will generate an engine speed but it will not synchronise.

Strange,
This is the second Subaru i see running only on the crankshaft sensor, vehicle was brought to us for an engine rebuild and remap and i was shocked to see that the camshaft sensor isn't even connected...
Is it possible that the engine is running on another "mode" ?

Thanks
dochka
 
Posts: 4
Joined: Wed Jun 22, 2011 7:23 am

Re: Subaru EJ25 Block / EJ20 Heads to Start Semi-Sequential

Postby Stephen Dean on Wed Sep 18, 2024 5:26 pm

I'd have to see how it is configured.

I have run all of the reference modes available in the M800 against the Subaru 36-2-2-2 trigger pattern and could not get any of them to synchronise without the Sync sensor. It may be that they have changed the trigger on the crank to be a 36-2 and that will work without a sync signal in two stroke mode.
Stephen Dean
MoTeC Research Centre Melbourne, Australia
User avatar
Stephen Dean
Site Admin
 
Posts: 1729
Joined: Tue Dec 02, 2014 10:29 am
Location: Melbourne


Return to M800 Plug-In ECUs

Who is online

Users browsing this forum: No registered users and 3 guests

cron