MoTeC Global Forum

Hey,

perhaps stupid question but im new at this so....
i have quite a few 2-wire msel temp sensors (SENTEMSSNPT) for my diffs , transmission etc.
the m150 doesnt have enough analogue temp sensor inputs.
msel datasheet states that it can work on 5v instead of groung resistance as well.
can someone tell me how to wire this 2pin sensor for use with any of the analogue voltage inputs on the m150?
thank you

Hi,

This diagram shows what needs to be done.

AT sensor into AV input by Stephen Dean, on Flickr

Bit of a wiring headache but it works fine thank you!

Stephen Dean wrote:Hi,

This diagram shows what needs to be done.

AT sensor into AV input by Stephen Dean, on Flickr

I assume this would also work for an AV input on the C125? Assume calibration table stays the same?

Correct and Correct.