Page 1 of 1
LTC CAN Bus Messages
Posted:
Thu May 05, 2011 9:04 pmby Mazi
There is also Message 3, ID-2 available but not documented.
Unknown messages are sent out from LTC on address 1CF8xxxx.
Any info available?
Re: LTC CAN Bus Messages
Posted:
Tue Jun 21, 2011 5:56 pmby JamieA
It is a debug message for Motec diagnostic use only.
you wont need to worry about it.
what version are you using, as I thought it wasnt meant to send it.
regards..
Jamie
Re: LTC CAN Bus Messages
Posted:
Wed Jun 22, 2011 1:11 pmby Mazi
Jamie
Firmware version is 1.04C
Re: LTC CAN Bus Messages
Posted:
Fri Dec 04, 2020 11:51 pmby Powertrain
Hi there,
it is possible to setup the LTC Controller without sending the Motec diagnostic messages?
When yes, how to do this?
Re: LTC CAN Bus Messages
Posted:
Mon Dec 07, 2020 10:16 amby adrian
No it isn't possible to turn the messages off, they are used for PC communications.
The address range of the messages is 0x1CF80000 to 0x1CF8FFFF.