There is also Message 3, ID-2 available but not documented.
Unknown messages are sent out from LTC on address 1CF8xxxx.
Any info available?
LTC CAN Bus Messages
5 posts
• Page 1 of 1
LTC CAN Bus Messages
by Mazi on Thu May 05, 2011 9:04 pm
-
Mazi - Posts: 146
- Joined: Thu Jul 24, 2008 8:45 pm
Re: LTC CAN Bus Messages
by JamieA on Tue Jun 21, 2011 5:56 pm
It is a debug message for Motec diagnostic use only.
you wont need to worry about it.
what version are you using, as I thought it wasnt meant to send it.
regards..
Jamie
you wont need to worry about it.
what version are you using, as I thought it wasnt meant to send it.
regards..
Jamie
- JamieA
- Posts: 454
- Joined: Wed Apr 30, 2008 3:16 pm
- Location: Melbourne, Australia
Re: LTC CAN Bus Messages
by Powertrain on Fri Dec 04, 2020 11:51 pm
Hi there,
it is possible to setup the LTC Controller without sending the Motec diagnostic messages?
When yes, how to do this?
it is possible to setup the LTC Controller without sending the Motec diagnostic messages?
When yes, how to do this?
- Powertrain
- Posts: 1
- Joined: Tue Dec 01, 2020 9:25 pm
Re: LTC CAN Bus Messages
by adrian on Mon Dec 07, 2020 10:16 am
No it isn't possible to turn the messages off, they are used for PC communications.
The address range of the messages is 0x1CF80000 to 0x1CF8FFFF.
The address range of the messages is 0x1CF80000 to 0x1CF8FFFF.
- adrian
- MoTeC
- Posts: 719
- Joined: Mon Apr 13, 2015 5:16 pm
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest