CDI8 wiring to M800
Posted: Sat Feb 27, 2010 4:07 amAccording to the Motec Manual the Can bus is only for diagnosis purposes. I've connected pin T to pin A3. Shall I connect the can bus from the CDI8 to the rest of the system CAN BUS
MoTeC Global Forum
The official support forum for MoTeC products
https://forum.motec.com.au/
CDI8 wiring to M800
Page 1 of 1
Posted: Sat Feb 27, 2010 4:07 amRe: CDI8 wiring to M800
Posted: Tue Apr 27, 2010 6:14 amPersonally, Not needed unless you have a SDL3/ADL3/ACL on the bus collecting that information.