Gents (and ladies!).
The CDI-8. The message I see that it sends via CAN to the ADL2. Do those messages apply if it is being run in standalone or does it also apply when the CDI-8 is in "slave" mode?
-Figgie
CDI-8 CAN Messages
2 posts
• Page 1 of 1
CDI-8 CAN Messages
by figgie on Thu Jul 31, 2008 6:48 am
- figgie
- Posts: 135
- Joined: Fri Jul 11, 2008 4:22 am
- Location: Minnesota, USA
Re: CDI-8 CAN Messages
by DarrenR on Thu Jul 31, 2008 12:00 pm
Figgie,
I believe the CAN messages are the same or fairly similar from stand alone to 'IEX' mode.
Stand alone mode is no longer available and information on it is very scarce so i can't be certain.
I believe the CAN messages are the same or fairly similar from stand alone to 'IEX' mode.
Stand alone mode is no longer available and information on it is very scarce so i can't be certain.
Darren Reynolds
MoTeC Research Centre - Melbourne, Australia.
MoTeC Research Centre - Melbourne, Australia.
- DarrenR
- MoTeC
- Posts: 176
- Joined: Thu May 01, 2008 2:15 pm
- Location: Melbourne, Australia
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest