MoTeC Global Forum

I assume the SLM-C will only operate at a CAN rate of 1Mbit/s. Is there anyway to configure it for a 500 Mbit/s bus rate?

The SLM will auto-baud so should work on any CAN bus without having to change anything. The SLM-C I am not so sure of. I was hoping to test it today but I couldn't actually find an SLM-C in the office.

I'll get one of the devs to confirm.

Actually my customer says it is working on his 500k CAN bus. I’ve never seen mention of the auto-baud feature of the SLMs. You should add that the the data sheet, website, etc.