MoTeC Global Forum

PDM 15 and 30 have now been released.

More information here:
http://www.motec.com.au/aboutpowerdistr ... noverview/

-Jamie

When will you have more stock of the 15's Jamie?

bump for an answer

Ok. I just went down and checked out what is going on...

There is no stock of PDM15's right now, the first batch sold out striaght away.

We have back orders already for half of the second batch of PDM 15's.
The second batch should be finished this afternoon.

Given current demand, we expect that we will run out again shortly.

So, due to demand, we have had to put an urgent forward push on the 3rd batch of units so that we are not out of stock for too long.

It is difficult to estimate demand on a new product, and we just need to reset out predictions on this one and try to keep up as best as possible in the mean time.

-Jamie

Thanks Jamie!

Tried to buy one Friday and just missed the last of the stock

I have an order in this 2nd run so fingers crossed.

You were good to your word Jamie, I picked mine up tonight thanks!

Pretty well have one with the lot now

MoTeC M800 ECU
MoTeC 816 Expander
MoTeC 2 axis G sensor
MoTeC EGT
MoTeC wb02
MoTeC DBW
MoTeC Logging
MoTeC SDL
MoTeC SLM
MoTeC SKM
MoTeC PDM15

IJ. wrote:You were good to your word Jamie, I picked mine up tonight thanks!

Pretty well have one with the lot now

MoTeC M800 ECU
MoTeC 816 Expander
MoTeC 2 axis G sensor
MoTeC EGT
MoTeC wb02
MoTeC DBW
MoTeC Logging
MoTeC SDL
MoTeC SLM
MoTeC SKM
MoTeC PDM15

Geez Ian!!

You can support a race team by yourself at this point!! lol///

Just a pity the Trans controller uses a slow CAN speed or I could intergrate it in without the hardwires