MoTeC Global Forum

Hello folks ,

I am trying to set up a logic for brake force display on my track car .Basically when brake pressure goes over a certain brake pressure value to flash the brake lights but when below the specified ( brake pressure ) to just be constant on .
I have both brake light switch and brake pressure signals coming into the PDM over CAN . The brake lights are wired to only 1 output . Would it be possible to achieve such logic ? Basically when BLS condition is true lights stay constant on and when brake pressure signal becomes true turn/flash to off .I have attached my config file.

Much appreciated,

Adrian

Hi,

Give this a try.

Thank you Stephen ! Worked fine .

Glad to hear.