Page 1 of 1

PDM30 Firmware update trouble

PostPosted: Fri Oct 19, 2012 2:34 am
by plosey
Hi, I have two of your PDM30's and i have moved to a new laptop. I need to update the firmware on one of the pdms from 1.4 to the new 1.5 (I can do this fine via the pdm software) however when i go to connect i get

Communications Error:
Read Operation Failed: PDM Halted reason code WRONG_CFG_VER

Attached is a screenshot of the error.
motecerror.jpg
motecerror.jpg (11.26 KiB) Viewed 9949 times

Re: PDM30 Firmware update trouble

PostPosted: Sat Oct 20, 2012 2:17 am
by GWRMOTORSPORT
Hi Plosey

I had a similiar issue when I tried to upgrade from 1.4 to 1.5 about a year ago,
If I recall the fix was to update the old 1.4 config file on the laptop into 1.5
and then update the pdm to 1.5 then resend the config file

Hope this helps

Steve

GWR Motorsport
UK

Re: PDM30 Firmware update trouble

PostPosted: Sat Oct 20, 2012 2:45 am
by plosey
Thanks, Yes that is the email i got from Motec as well and it did work. was a simple fix just needed a point in the right direction, TY