Unused channel reports 142% load
Posted: Sat Sep 15, 2012 6:33 amHi,
I have PDM 32 and PDM 16's across several cars and have this problem with all units, so I dont think its unit specific. If I have been using an output channel and then delete all conditions from the channel, the reported LOAD over the CAN stream is 142% when it should be 0%. Other than putting a dummy set of conditions in the channel, is there a workaround this?
Thanks guys,
J.
I have PDM 32 and PDM 16's across several cars and have this problem with all units, so I dont think its unit specific. If I have been using an output channel and then delete all conditions from the channel, the reported LOAD over the CAN stream is 142% when it should be 0%. Other than putting a dummy set of conditions in the channel, is there a workaround this?
Thanks guys,
J.