MoTeC Global Forum

Posted: **Wed Mar 23, 2011 6:31 am**

I'd like to build a basic programming loom to configure my spare PDM32 away from the car;

Connector A
A_10 CAN Low ->UTC 4
A_11 CAN High -> UTC 5

Connector B
B_b Batt–
B_c Batt–

Connector C
C_1 Batt+

Are these the only connections I need to make to program it?

TIA

Posted: **Tue Mar 29, 2011 4:25 pm**

yes, that is all you will need.

regards

Jamie

Posted: **Mon Feb 20, 2012 2:58 am**

The schematic for the chassis loom I have that interfaces with the PDM 32 also has a ground connected to Pin 1 on the UTC - is this necessary as well?

Posted: **Tue Feb 21, 2012 4:31 pm**

Power for the PDM,
CAN Hi and CAN Lo for the UTC are all that you need.

regards,

-Jamie

MoTeC Global Forum

PDM32 Programming Loom

PDM32 Programming Loom

Re: PDM32 Programming Loom

Re: PDM32 Programming Loom

Re: PDM32 Programming Loom