MoTeC Global Forum

Hi

I’have a question about using PDM 15, M800 and UTC. My M800 is connectet to output xx of the PDM the UTC is connectet to canbus, Aux 8V and Aux 0V of the M800. At the first Startup only the PDM is connectet to Bat. and Ground so the M800 is off. Is it poosibel to configure the PDM without 8V for the M800?

Regards Thorsten

Thorsten,

Only the very old can Cables used the 8v. On a UTC the 8v is not needed as the USB port supplies its power

Thanks

Yes, the PDM is not compatible with the parallel port CAN Cable for this reason. It is UTC only.