MoTeC Global Forum

When looking at the channels passed from the E888 to the SDL via CAN I see reference to "exhaust temp # (obselete)" I this normal and if not what am I doing wrong ?

Thank You

Normal, it says that because it's a lower sample rate I think.

These channels come up as Obsolete because there was a change made to the Master Channel list. The channels will work ok and you can re-name them in the Channel Editor if you want to .

Never been able to get EGT's to display on the SDL using the exhaust temp channel any suggestions Ross?

it should just work by selecting the correct channel name. Perhaps post your config to let me have a look...

-Jamie

Steve T has copies of all my files Jamie, I'm in the middle of a total revamp so it's not really important now but I will post again once the car is running.