MoTeC Global Forum

I have been trying to avoid asking this question as I'm sure I'm missing something fairly obvious but I cannot get my SDL to display the next line no matter what I do. I can switch display "modes" but cannot get the next line to come up. I have a simple switch feeding the "display next line" parameter and have confirmed that it works in the monitor channels window.

Attached is my calibration file for review...

You have to set up the channels for the Mode, Next line etc. This is done in the Display Setup menu under the Channels Tab. You have a display Next line button setup but I cannot see a Mode input in your configuration?

Embarrassing, as I suspected (how did I miss that )

There is no mode button needed to change modes, I have it setup to change modes when the alarm ack button is pressed for more than 2 or 3 seconds (didn't seem worth adding a separate button). Funny the function I took the back way around works but the one that should be simple doesn't.... I made the poor assumption that the "display next line" button would automatically setup to do so. Thanks for the quick response