Does anyone know if i can link between both?
Any additional hardware required ?
Thanks!
SDL with EVO-X Factory ECU
2 posts
• Page 1 of 1
SDL with EVO-X Factory ECU
by yaron on Sun May 31, 2009 7:09 pm
- yaron
- Posts: 1
- Joined: Wed May 27, 2009 4:39 pm
Re: SDL with EVO-X Factory ECU
by DarrenR on Wed Jun 03, 2009 10:21 am
Hi,
Yes we have CAN templates for the EvoX. You don't need any additional interface, just need to splice into the cars main CAN bus.
The SDL is limited in the amount of data it can receive tho, so you depending what data you need you may end up with a minimum of only 6 channels.
Yes we have CAN templates for the EvoX. You don't need any additional interface, just need to splice into the cars main CAN bus.
The SDL is limited in the amount of data it can receive tho, so you depending what data you need you may end up with a minimum of only 6 channels.
Darren Reynolds
MoTeC Research Centre - Melbourne, Australia.
MoTeC Research Centre - Melbourne, Australia.
- DarrenR
- MoTeC
- Posts: 176
- Joined: Thu May 01, 2008 2:15 pm
- Location: Melbourne, Australia
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 17 guests