Page 1 of 1
cdl3 crashing on warmup tab
Posted:
Wed Jul 04, 2018 11:53 amby Entranced
Downloaded my calibration I got from my tuner off the dash and started looking at the screens and I get "unit type not found" message (see attached) and the program crashes.
I contacted my tuner and sent him the calibration file and it opens normally on two of his computers without issue.
Any ideas? Thanks!
Re: cdl3 crashing on warmup tab
Posted:
Wed Jul 04, 2018 1:17 pmby adrian
Can you please try copying the below file to C:\Program Files (x86)\MoTeC\Common\1.0\Units\en and see if that fixes the problem.
Couple of things to note:
Make sure you close Dash Manager before you copy the file.
If you are asked to override the existing file, click yes.
Re: cdl3 crashing on warmup tab
Posted:
Wed Jul 04, 2018 1:39 pmby Entranced
replaced the units file with the one you attached but it didn't resolve the fatal error. still crashes only on warmup tab.
Re: cdl3 crashing on warmup tab
Posted:
Wed Jul 04, 2018 2:16 pmby adrian
Ok, can you please send your config file to
support@motec.com.au and I'll take a look at it.