MoTeC Global Forum

My CDL3 firmware currently has communication templates for receiving base CAN messages from two PDMs. I need my CDL3 to receive base CAN messages from three PDM16s. Any firmware update that will permit this or workaround Motec recommends?

--Peter

Jeepers Peter!!!

How many PDMs do you need?!!!

Lol! Well, Adam, eliminating all fuses and all but one relay while maintaining some of the car's creature comforts has proven a challenge! Two PDM32s would have done the trick, but I liked the ability to locate the smaller PDM16s close to their outputs.

Herrubermensch wrote:Lol! Well, Adam, eliminating all fuses and all but one relay while maintaining some of the car's creature comforts has proven a challenge! Two PDM32s would have done the trick, but I liked the ability to locate the smaller PDM16s close to their outputs.

Have you been accused of building an LMP car yet?

Regarding the original question: No need for new firmware, just manually configure the CAN IDs.

PEI330Ci wrote:

Herrubermensch wrote:Lol! Well, Adam, eliminating all fuses and all but one relay while maintaining some of the car's creature comforts has proven a challenge! Two PDM32s would have done the trick, but I liked the ability to locate the smaller PDM16s close to their outputs.

Have you been accused of building an LMP car yet?

Regarding the original question: No need for new firmware, just manually configure the CAN IDs.

I have been accused of everything from time to time!

So I would think as well. Will play with it.

--Peter