Page 1 of 1
Connect tyre temp sensors by CAN to ADL3
Posted:
Mon May 09, 2011 11:21 pmby gust0214
We buy two texense sensors IRN8 (tyre temperature in 8 points) this sensors need CAN connection we have connected in CAN 1 the beacon when I use. Is possible that you give me the steps to connect this sensors and setup the CAN?
We wait your response to soon as possible
Re: Connect tyre temp sensors by CAN to ADL3
Posted:
Wed May 11, 2011 10:11 amby JamieA
can you please send me the documentation on this unit, so that I can look at how we can set it up.
regards
jamie.
Re: Connect tyre temp sensors by CAN to ADL3
Posted:
Wed May 18, 2011 12:46 amby gust0214
Dear Jamie
I send you the data sheet of this sensors
thank you for your help
Re: Connect tyre temp sensors by CAN to ADL3
Posted:
Mon May 30, 2011 11:07 pmby gust0214
Dear Jamie
any news for me
i wait your response to soon as possible
Re: Connect tyre temp sensors by CAN to ADL3
Posted:
Mon Jul 18, 2011 11:07 amby OmarK
Hi,
Attached is the default CAN comms template for the Texense IRN8 sensor for use in SDL3 and ADL3 via CAN. Load this into a spare CAN template in the Communications Setup. The template was made a few years ago but should still work, let us know how you go...
Re: Connect tyre temp sensors by CAN to ADL3
Posted:
Fri Nov 09, 2012 5:12 amby mangel83
Hi Omar,
Would you happen to have the CAN comms template for the Texense IRN4 sensor for use in ADL2?
Re: Connect tyre temp sensors by CAN to ADL3
Posted:
Mon Nov 26, 2012 12:07 pmby OmarK
From what I have heard from Texense, the IRN4 is the same as for IRN8 with only 1 CAN ID used for the 4 channel sensor.