Display Next Line (SDL)

[Ben-S]

I have been trying to avoid asking this question as I'm sure I'm missing something fairly obvious but I cannot get my SDL to display the next line no matter what I do. I can switch display "modes" but cannot get the next line to come up. I have a simple switch feeding the "display next line" parameter and have confirmed that it works in the monitor channels window.

Attached is my calibration file for review...

[RossB]

You have to set up the channels for the Mode, Next line etc. This is done in the Display Setup menu under the Channels Tab. You have a display Next line button setup but I cannot see a Mode input in your configuration?

[Ben-S]

Embarrassing, as I suspected (how did I miss that )

There is no mode button needed to change modes, I have it setup to change modes when the alarm ack button is pressed for more than 2 or 3 seconds (didn't seem worth adding a separate button). Funny the function I took the back way around works but the one that should be simple doesn't.... I made the poor assumption that the "display next line" button would automatically setup to do so. Thanks for the quick response