Page 1 of 1
SDL Config upload
Posted:
Fri May 31, 2019 3:04 pmby WayneMolloy
I have a SDL , when i upload a config file i get a error message afterwards, the config file does seem to upload but I'm not sure why the message pops up. the error box reads " Send Configuration" , Error reading from device memory operation failed CAN Bus error.
Can someone help
Re: SDL Config upload
Posted:
Mon Jun 03, 2019 12:38 pmby adrian
Are you connected to the Dash directly with USB or are you connected via CAN with a UTC?
Re: SDL Config upload
Posted:
Mon Jun 03, 2019 4:15 pmby WayneMolloy
I have a UTC connected to the SDL
Re: SDL Config upload
Posted:
Mon Jun 03, 2019 6:07 pmby adrian
Is there are reason you are using a CAN connection rather than directly connecting with USB? Does everything work once you have sent the config even though you get the error message?
Re: SDL Config upload
Posted:
Tue Jun 04, 2019 11:07 pmby WayneMolloy
Hi Adrian
I have a M84, SLM and a LTC connected to the SDL via CAN with one diagnostic port, i only connect to ECU or SDL.
I am getting Temp and RPM from the ECU but still struggling with the lambda signal (LTC 4.9)
Re: SDL Config upload
Posted:
Wed Jun 05, 2019 9:47 amby adrian
Can you please send me both your M84 and SDL configs, you can send them to me at
support@motec.com.au
Re: SDL Config upload
Posted:
Tue Jun 11, 2019 12:01 amby WayneMolloy
Hi Adrian
I have sent you the requested config files, hope it is what you need, thanks