Page 1 of 1
ADL1 to PDM Communication
Posted:
Tue Oct 14, 2008 10:11 amby Spline Tech
Is there a way to make this work?
It looks like the old Dash Manager 3.2 software is looking for .CC4 CAN templates and all the PDM CAN templates are .CC7.
Re: ADL1 to PDM Communication
Posted:
Tue Oct 14, 2008 11:12 amby JamieA
yes, you can make it work, but the problem is that ADL1 does not have compound CAN messages. So you are really restriced on which channels you can get before you run out of can templates. So think carefully about what you really need to get, and manually set up your own templates to suit.
Re: ADL1 to PDM Communication
Posted:
Tue Oct 14, 2008 12:47 pmby Spline Tech
Can you elaborate?
Can you give an example of sending an ADL Condition to the PDM and sending a PDM Output state to the ADL?
Thanks.
Re: ADL1 to PDM Communication
Posted:
Tue Dec 01, 2015 8:46 amby ElectronSpeed
I have a customer upgrading his all Motec system with a PDM. Are there any premade *.cc4 templates yet or should I start typing?
thanks,
Eric Schieb