MoTeC Global Forum

Posted: **Mon Feb 21, 2011 4:19 am**

Hi mate!
How can I connect the fuel level sensor to ADL in EVO 9?
I would like the ADL write the fuel level!

Anybody?

Best regards

Sacaboy

Posted: **Mon Feb 28, 2011 9:08 am**

As you may know, the fuel level sensor is not connected to the M800 PNP. So you should be able to wire this sensor into the ADL. If it is a resistive sensor then you will need to measure the resistance with different fuel levels and use an AT input into the ADL with the appropriate input calibration... If it is a varaiable voltage sensor then you will use an AV input... you will need a wiring diagram of the car and multimeter... hope this helps

Posted: **Wed May 25, 2011 3:30 pm**

http://www.ironcanyonmotorsports.com/pr ... ucts_id=28

instructions are on that site as well

MoTeC Global Forum

Fuel level on ADL

Fuel level on ADL

Re: Fuel level on ADL

Re: Fuel level on ADL