Page 1 of 1
Inj5 to 8 in M400
Posted:
Thu Jan 21, 2010 1:15 am
by Wolf_Tm250
Hi All,
I searched on manual and in the forum, but I didn't got a reply.
I know that I can (must) use Inj8 for knock window, but what about the other 3 output (Inj 5 & 6 & 7) ?
Could I use it as auxiliary output in the M400?
Thank you.
Re: Inj5 to 8 in M400
Posted:
Fri Jan 22, 2010 3:24 am
by Martin
No you cant.
Even if you ran a single cylinder you could not use 2.3.4 as spare outputs.
Re: Inj5 to 8 in M400
Posted:
Sun Jan 31, 2010 8:54 pm
by Wolf_Tm250
Have not the possibility to use as spare outputs the unused injectors output is a real pity...
even because they showed they could make it just via software release...
Re: Inj5 to 8 in M400
Posted:
Sat May 01, 2010 12:11 am
by mr2andy
Hey buddy..
I'm running a M400 on my MR2-3SGTE as well. Which knock module did you pick for capturing the knock?
Cheers
Re: Inj5 to 8 in M400
Posted:
Sat May 01, 2010 1:54 am
by Wolf_Tm250
mr2andy wrote:Hey buddy..
I'm running a M400 on my MR2-3SGTE as well. Which knock module did you pick for capturing the knock?
Cheers
I use the Motec SKM...