Alloytech cam control

[AaronM]

Hello All,

I am trying to get the camshafts synced on a 190kw Alloytech. So far all is well but 1, the left intake.

The right intake is the sync one. I can get it to work with an offset of 60. No worries until you turn it off and restart and it shows the cam degree to be 45 approx. Drop the offset to 15 and back to 60 and its fine again. I think it is because it somehow reads from the next tooth on the cam. All cams have 4 teeth. On falling edge they are all even but not on rising edge.

Sync is set to rising and ref/sync mode 17.

Any ideas?

Thanks guys