Wiring help! Motec CAN female connector - Deltron 716-0-0501

[mr2andy]

Guys,
I bought the DEM 724-0501 (Non Latching) connector from Motec and have no idea how to wire it up with the wiring harness. Can anyone help?

Cheers
Andy

[MarkMc]

Hi Andy,
The wiring is on all the ECU drawings for the M400, M600 and M800 but for the record the pin out is:

1: 0v comms (ECU B14)
3: 8v (ECU A13)
4: CAN Lo (ECU B24)
5: CAN Hi (ECU B23)

[mr2andy]

Thanks Mark,

Which pin is no1, no2, ... on the plugs?

By the way, do I crimp the wires directly to the pin on the connector or soldered them on and wire heat shrink it?

Cheers
Andy

[IJ.]

Grab the data sheet here Andy

http://www.motec.com.au/filedownload.ph ... docid=1214

M800 pins crimp directly to the wire no need for heatshrink as it won't go into the weather seals on the plugs.

[mr2andy]

Thanks buddy... = )

[IJ.]

Very welcome Andy!

It's a good idea to get the correct crimper for these pins as well as the hole in the body of the plug doesn't leave room for anything other than a nice roll crimp on the insulation.

They're a bit spendy but worth their weight in gold

[mr2andy]

Guy,
my problem is... by looking at the DEM adapter.. i don't know which pin is 1, 3, 4 and 5?

[IJ.]

Guy,
my problem is... by looking at the DEM adapter.. i don't know which pin is 1, 3, 4 and 5?

They're marked pin #1 is the one with the red pin inserted

[mr2andy]

My bad.. I saw that when I took the part off the plastic package...

Thanks for the information bro..

Cheers
Andy

[IJ.]

WHAT!!

I went out in the cold at 7am for nothing??? <jk>

No probs Andy!