MoTeC Global Forum

Posted: **Thu Jun 04, 2009 9:05 pm**

Hi,
I have a Dash 0-12000rpm, but my motor only revs up to 10500. I would like the 9000-12000 bars display 9000-10500rpm. Unfortunately, the Tacho output function can only vary the duty cycle.
Can I use an AuxN as frequency output, where the frequency value comes from a table ?

Angelo

Posted: **Fri Jun 05, 2009 12:40 am**

Post about similar problem found here http://www.motec.com.au/forum/viewtopic.php?f=11&t=543&p=2476&hilit=frequency+table#p2476
but no answer.

Angelo

Posted: **Fri Jun 05, 2009 10:15 am**

To do this you would need a duty cycle and frequency function, the M800 doesn't have this.

MoTeC Global Forum

non-linear tacho output

non-linear tacho output

Re: non-linear tacho output

Re: non-linear tacho output